Looking for heat sink simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Demonstration project of an electronics enclosure using CHT v2. Comparison different passive heat sink designs and comparison of active and passive cooling

natural convection cooling of a thermoelectric generator setup with heatplate including radiation

This is a project to simulate the heat dissipation of a heat sink. A heat sink is a component that increases the heat dissipation of a device or an assembly.  A conjugate heat transfer simulation will be used to illustrate how heat flows away from the component. They are usually found in HVAC  systems, power plants and electronic appliances. The model was generated in CATIA v5.

In this project, I will analysising the temperature attained during heat sink

Making sure that the custom heat sink has a low enough thermal resistance to cool the peak detector circuit's op-amps

Know the difference in efficiency in a heat-sink depending on the position of the sink pipes

Checking the stimulation with analytical values

Breakdown of heat sink efficiency based on inlet and outlet sizes

Natural Convective Heat Transfer of a computer chip and fin assembly

Test natural and forced convection with conjugate heat transfer of a heat sink.
Added thermal pad as thin layer resistance and small flow region as enclosure.

A fully enclosed bedside LED lamp with about 700lm

This Project is to study the flow of heat from Heat Block to other extruder components

Designing of a  porous  aluminium heat sink for ZOHD  VC-400  camera.

The presented project is an analysis of the thermal performance of a heat sink connected to chip. The chip acts as a power source generating 30W of heat. Using a conjugate heat transfer analysis allows for simulation of heat transfer between the solids via conduction and the dissipation of heat into the ambient fluid via convection. The components are cooled passively and buoyancy effects  drive the flow in the surrounding air.

The objective of this project is to evaluate the max temperature of the chip during operation and therefore a steady state analysis was carried out.

heat sink | SimScale Project Library | Page 1