SimScale simulation projects by ojagtap | Page 1

ojagtap's profile

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

This project simulates instantaneous turbulent wake of a cylinder body via LES method.

This project simulates opening of a pressure relief valve using 6 DOF body motion.

FSAE-Workshop-S3- Yaw angle- Analysis-Simulation

Related to step-by-step tutorial of the biomedical workshop (session 1)

https://www.simscale.com/forum/t/biomedical-engineering-workshop-session-1-stress-shielding-in-a-hip-joint-prosthesis/36830/3

Weight is one of the most critical parameters in aircraft design. In this exercise, you will be provided with a baseline design of an aluminum aircraft wing. Your objective is to reduce the weight of the wing without exceeding the yield stress and maximum allowable deflection

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

For step by step tutorial see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-1/78878
2. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-2/79350

This project simulates incompressible flow through an industrial scale Butterfly Valve.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

The effect of numerics on the simulation quality and convergence time.

This is used as a starting point for the SimScale Users and participants of the Session  2 of the All-Terrain Vehicle Design Workshop

This project involves a static structural simulation of an aircraft wing which is subjected to bending and torsional load due to wind pressure.

Public Profile

ojagtap's profile